The largest panel in the Fluffo Art collection - its hallmark. It looks great among the other Fluffo ART elements, as well as an autonomous acoustic wall decoration. The quality of the form is underlined by the glistening copper inset.
Second in size panel in the collection. It looks equally good in the vertical and horizontal position. The parameters of the circle and the rectangle are the same as in the Art 1 element.
Clean geometrical form, built of two distinct elements. The square emerging from a circle is located more symmetrically in comparison to the Art 1 element, this makes the whole piece visually balanced.
Similarly, to Art 5 it is a strong accent of the entire collection. It looks good as part of the collection, and just as good presented autonomously. Due to the large surface of the panel, it is very important to choose the colour carefully, as the piece should not blend into the wall, but also shouldn’t irritate with brightness.
Just as with Art 4 this panel looks good alone as well as a part of the collection. In a large space, it will look best next to the same model or a whole series of panels.
What is Fluffo made of?
Fluffo layer (1mm)
The colourful Fluffo finish. Millions of tiny polyamide fibres (1mm in length) glued vertically to the surface. Remember! Fluffo finish is antistatic and light-fast.
Foam layer (2 to 5 cm)
Flexible, high density polyurethane foam exceptionally resistant to ageing.
The installation of the Fluffo panels is simple, quick and clean.
You can do it yourself with no problem. We always enclose the installation instructions to each shipment.
The panels should be affixed to the wall using a flexible mounting adhesive with high initial bonding. Since Fluffo panels are extremely light, they will not fall off the wall during the installation.
A thin layer of the adhesive should be applied to the outline of the panel, then press the panel firmly into place. After application of the adjacent panels, you can adjust their position. You are done!
Fluffo panels can be cut to obtain a desired dimension. The cut will reveal the white structure of the foam, that is why we cut panels only in the case when the cut edge will not be visible i.e. when it will be adjacent to the ceiling or a perpendicular wall.
Fluffo Fix is available in our Fluffo offer – it is a tested, odourless adhesive with high initial bonding and minimal shrinkage intended for Fluffo panel mounting.
The great advantage of this adhesive is the fact that it remains flexible up to 40 minutes, which allows the adjustment of the position and fit of the panels during the installation in order to obtain the perfect effect.
Fluffo Fix contains a special penetrating agent, thus there is no need for special wall preparation before panel installation. Just make sure that the wall is relatively even and free of dust.
Please see the downloads section for a complete installation guide.
The Fluffo finish covering our panels is antistatic and does not attract dust. However, dust can settle on the panels just like on any furniture. Horizontal surfaces sticking out beyond the line of the adjacent panels are particularly vulnerable.
In order to remove dust, use a soft brush or a vacuum cleaner with a standard brush for upholstered furniture.
Lightweight stains can be removed with a soft sponge slightly moistened with diluted detergent. When cleaning please wipe the whole panel surface, so that you don’t leave rubbing traces in one spot.
In extreme cases, when the stain penetrated into the panel and despite the cleaning is still visible, the dirty panel can be easily replaced with a new one.
Be sure not to over rub the panel surface with a wet sponge and avoid strong detergents, such as bleach or washing powder.
Note: Batch to batch variations in shade may occur within commercial tolerances. Electronic colours in the electronic fabrics swatch may differ from real colours.